Garage Door Closes With Jerks

This is almost always the result of a dirty or obstructed safety feature.

Garage door closes with jerks. When the rollers hit debris in the track it will cause the door to jerk. After ruling out a problem with your garage door opener use the three step guide below to take steps towards removing possible causes. The garage door runs on the track system that keeps it in place during opening and closing. It is the lift motor that pulls the door up and then lets it down so it can close.

Garage door jerks on opening. Garage door jerks when it closes. The door raises fine but when it closes the door gets jerky. Doesn t seem to be flexing at coupler attachment to ra.

I have a large spring over the door i do not have the side springs. It might be damaged dirty or have debris in it. If you have noticed that your garage door is jerking every time you open or close it you may decide to take action to make it open more smoothly. The door is probably 25 years old but the genie is only 5 years old.

You push the button to close the garage door. Check the tracks for debris and loose screws. When the garage door is jerking or shaking during operation it can be caused by the track being dirty or damaged. If your garage overhead is getting jammed or shaking and jerking as it closes the tracks should be checked.

When the door is opening or closing it runs on a set of tracks which keep the door in place. In addition the track needs to be aligned correctly for the door to work properly. The lift motor is responsible for working in unison with the springs to pull the door up and lets it back down when it should close. The door hit the bumper of the car.

I have tried limit and force adjustments and checked door movement in tracks not sticking to floor. It goes partway down reverses direction and goes back up again. My friend closed the garage door while the car was not quite in. It looks like the chain guide bangs into the door to push it.